I want to do C2® calibration with a HI 200DNWM while having live weight in the vessel. How do I tell the system what the live weight is as a reference?
What are the correct terms that nationally recognized Testing agencies, Factory Mutual, Underwriters Laboratories, Mine Safety and Health Association and the Canadian Standards Association use?
I am replacing a load cell on an existing scale and unable to read the label. Is there another way to figure out what the capacity of the load cell is?
Using the RSLogix5000 ladder program for the HI 1756WS module downloaded from Hardy's web page, what is the procedure to perform a C2® calibration? Changing just the Start C2® bit from 0 to 1?
Why can't I communicate from the HI 2110WI, HI 2151/20WC, HI 2151/30WC or the HI 2160RC, to the SLC Scanner module when I have more than 16 devices configured?
What is the proper procedure for doing a C2® calibration to set the Cal Low and the Span (Cal High) on my HI 200DNWM? Do I need to use test weights for a C2® calibration? Also, can you provide a node address list to set the dip switches for the balance of address not shown in the small handouts?
