Hardy Process Solutions

Filter

Results: 51 - 60 of 78

Why is my C2® load cell count incorrect?

I am performing a C2® calibration and the displayed load cell count is incorrect. What could be wrong?

Why must the Sense Lines be used with C2® Second Generation Calibration?

Why must the Sense Lines be used with C2® Second Generation Calibration load points?

Where does my HI 215IT summing box get power?

What is the operational temperature range for Hardy Junction Boxes?

What is the operational (specified) temperature range for the HI 215JB standard Hardy junction box and for the HI 215IT Integrated Technician junction box?

Why does my HI 3010 get an A/D Conversion error when doing a C2® calibration?

Why do I get a A to D Conversion error when I try to do a C2® calibration on my HI 3010?

Can I run the load cell, signal or other communications cable in the same conduit as other cabling?

Can I run the load cell cables in the same conduit as my 24 VDC digital signal wires and EtherNet cable? Does the milli-volt signal wire need to be shielded?

Am I required to use C2 cable? What are the C2® cable specifications?

Am I required to use Hardy's C2® cable, and what are the C2® cable specifications?

Can you explain the meaning of the IT Test Result Data?

Can you explain the meaning of the IT Test Result data? The Gross values makes sense to me, but Internal weight, JBOX weight and mV Per V's don't.

Does any Hardy Instrument come in an explosion-proof box?

Does the HI 3010 come in an explosion-proof box?

Why doesn't my weight change after installing a HI 215IT summing junction box?

I installed an HI 215IT summing junction box on my system and now the weight does not change. I measure a constant 9 Mv on TB9 (Signal + and Signal -) even when I add or remove weight. What is going on?

Knowledgebase

Categories