You have no items in your shopping cart.

New HIDS Drum Scales!

Click Here to Learn More!
Sales: 858.278.2900
Support: 858-292-2710
Visit hardysolutions.cn
menu menu-close
Build Your System
Products
Products
Solutions
Solutions
Customers
Customers
Why Hardy?
Why Hardy?
Soutien
Soutien
Where to Buy
Where to Buy
Find Your Weighing Solution

Knowledgebase

Filter Filter button
Results: 11 - 20 of 540

Categories

How do I calibrate my HI 2151/30WC using NTEP?

How do I setup and calibrate my HI 2151/30WC using NTEP?

Do I need to use a jumper when connecting C2® in the HI 215IT summing junction box?

Do I need to use a jumper when connecting C2® in the HI 215IT summing junction box? Can I get a drawing for this?

Is the six relay option external on the HI 2151/30WC?

I want to add a six-relay output option to HI 2151/30WC. Is this relay option internal or external to my controller? What other information can you provide?

Why do I get an ERROR 62 when I use C2® calibration?

When I attempt to set my reference point on my HI 2151/30WC I get an error 62. This happens on newer C2® load cells and on ones that I have never been able to get C2® to work.

How many Load Cells can I connect to a Junction Box?

How many Load Cells can I connect to a Hardy Junction Box?

Do I really need to use a summing Junction Box?

Is a summing junction box necessary when the load cells are physically close enough to connect directly to the module or controller?

Why is my PLC reading differently than my controller?

I have a communications problem between my controller and the PLC. The PLC weight reading is higher than the reading displayed on the front of the controller. What could be the problem?

Does Hardy Instruments sell direct to end-users?

Does Hardy Instruments sell directly to system integrators, OEM's or End Users?

Why do I get an ERREXC when swapping SMM?

When I have a failed or suspected bad HI 2151/30WC, I swap out the unit to help isolate the problem. I do this by installing the current SMM into the replacement HI 2151/30WC. Then all the configuration and calibration information is supposed to be transferred. This should make for a fast and efficient transfer, but the problem is I am getting an ERREXC error displayed. Why do I get an ERREXC when swapping SMM?

How can I get a CAD Drawing for my Hardy product?

How can I get a "CAD Drawing" of a load point or other Hardy product?