Hardy Process Solutions

Results: 21 - 30 of 828

If Hardy does not have the right capacity load cell, what should I do?

Hardy does not have a 5,000 pound load point. What load point should I use when a 5KLB load cell is required?

Do I really need to use a summing Junction Box?

Is a summing junction box necessary when the load cells are physically close enough to connect directly to the module or controller?

Why is my PLC reading differently than my controller?

I have a communications problem between my controller and the PLC. The PLC weight reading is higher than the reading displayed on the front of the controller. What could be the problem?

Has the HI 1746WS configuration software changed since it's release?

Has the HI 1746WS software (HI WS100) changed since it's release?

Does Hardy Instruments sell direct to end-users?

Does Hardy Instruments sell directly to system integrators, OEM's or End Users?

What is the standard length of the cable that comes with a Hardy platform and bench scale?

What is the standard length of the cable that comes with a Hardy Platform and Bench scale?

Why do I get an ERREXC when swapping SMM?

When I have a failed or suspected bad HI 2151/30WC, I swap out the unit to help isolate the problem. I do this by installing the current SMM into the replacement HI 2151/30WC. Then all the configuration and calibration information is supposed to be transferred. This should make for a fast and efficient transfer, but the problem is I am getting an ERREXC error displayed. Why do I get an ERREXC when swapping SMM?

Knowledgebase

Categories