My weight reading is fine until I reach weights of 32,767 lbs. After this, it rolls over to a negative number. Why isn't my instrument reading correct above 32,767 lbs?
I do not get a TGERR on my HI 2151/20WC display but still lose parameter settings and/or calibration data. I do not receive this message even though the units have a SMM 1205 with firmware 0650-0069. Is the battery inside the SMM unit weak?
I have a blank display and found the fuse was blown. When I install a correct replacement fuse, it also blows at power up. Why am I blowing fuses on my HI 2151/30WC, HI2110WI, or HI 2151/20WC?
I have vessels and tanks with large mixers that are breaking the bolts on the Legacy HI LPS series load cells. Is there a problem with the installation or the bolts that could be causing this?
Can I calculate the expected Millivolt reading of my scale? I want to place a test weight on the scale and know what the expected signal Mv load cell output increase will be.
My weight reading does not start at zero with an empty vessel or locks at a high weight level. My contractor said something about linear correction. What exactly is linear correction and what are some indications of a poor linear correction?
