You have no items in your shopping cart.

New HIDS Drum Scales!

Click Here to Learn More!
Sales: 858.278.2900
Support: 858-292-2710
Visit hardysolutions.cn
menu menu-close
Build Your System
Products
Products
Solutions
Solutions
Customers
Customers
Why Hardy?
Why Hardy?
Soutien
Soutien
Where to Buy
Where to Buy
Find Your Weighing Solution

Knowledgebase

Filter Filter button
Results: 671 - 680 of 828

Categories

What is the data configuration in the DeviceNet Scanlist for the HI 200DNWM?

When I add the "HI 200DNWM" to my DeviceNet Scanlist it reserves 4 bytes of data on the input side, none on the output side. What exactly is the configuration of this data? (i.e. Status Bits and Gross Weight?) In the new HI 200DNWM Series B there is a 4 byte output field in the scanner table, for reading/writing parameters. How are these used?

How do I wire my non-Hardy load cells to the Hardy unit?

How do I wire my non-Hardy load cells to my Hardy unit? I am using non-Hardy Load Cells with a junction box made by the same company that made my load cells. They have an output cable of 7 wires at 24 VDC. How do I connect the cable to the Hardy unit? Can I use C2®?

How do we configure RS-422 for the HI 2151/30WC?

Our contractor didn't finish the installation properly and now we have to figure out how to configure the RS-422. What is the recommended software/hardware configuration to communicate between 1 GE PCM 311 input card and 2 Hardy HI 2151/30WC weight controllers using RS-422?

How do I set up the bar graph for incremental weighing on the HI 2151/30WC?

How do I set up the bar graph for incremental weighing on the HI 2151/30WC?

What is the ZERO button for on my HI 2110WI and HI 2151/30WC?

What is the ZERO button for on the front of the HI 2151/20WC, the HI 2151/30WC, and the HI 2110WI?

How is the totalizer function operated?

I keep checking the Totalizer readings by pressing the Mode button and the totalizer always says zero(0). Why won't the Totalizer readings change?  

Is there an applications guide available for the HI 3010?

Is there an applications guide available for the HI 3010 Filler/Dispenser?

Will my HI 1746WS function in a remote rack/chassis?

Will my HI 1746WS function in a remote rack/chassis, or must it be located in the SLC500 local rack/chassis ?

How do I zero the scale at power up using a HI 1771WS?

I am using a 1771WS series A module. I need to zero the scale at power-up. The incoming weight reads 4000 lbs. The net value reads 4000 lbs. When I tare the scale the net value is now 0 lbs. This is OK. At power-up the incoming and net now read 4000 lbs. I have tried to zero the scale, but it doesn't seem to work. I need the required PLC-5 ladder to perform a zeroing function at power-up.

How do I determine the correct grad setting for the best decimal point resolution?

I want to use my HI 2110WI, HI 3030, HI 4050, or HI 2151/30WC in a weighing application and was hoping to use 100 pound increments for a 800,000lb application. I understand that this is at the limit of the unit and that perhaps 200 pound increments would be better?