You have no items in your shopping cart.

New HIDS Drum Scales!

Click Here to Learn More!
Sales: 858.278.2900
Support: 858-292-2710
Visit hardysolutions.cn
menu menu-close
Build Your System
Products
Products
Solutions
Solutions
Customers
Customers
Why Hardy?
Why Hardy?
Soutien
Soutien
Where to Buy
Where to Buy
Find Your Weighing Solution

Knowledgebase

Filter Filter button
Results: 391 - 400 of 828

Categories

How do I calibrate while in motion?

How can I calibrate while in motion? My controller is used in conveyor belt weighing.

How can I switch from gross to net weight on the HI 3010 stand-by display?

How can I switch from gross to net weight on the HI 3010 stand-by display?

How do I zero out my instrument?

How do I zero out my HI 2110WI, HI 2151/30WC or my older HI 2151/20WC?

Do I need to calibrate my Hardy load cells?

Is there any calibration required on Hardy Load Cells, and if so what is the frequency of the calibration?

Does the HI 1746WS software work on DH+?

I am trying to use the HI WS100 Configuration software through RSLinx over DataHiway+ (DH-Plus). After entering the correct information on the Comm. Setup screen, when I go to any other screen the software starts loading (by the bar graph at the bottom of the screens). The software then locks up, the bar graph flickers and I have to use task manager to shut it down. Does the HI WS100 software work on DH+?

How do I make a load cell simulator?

I have a controller set up in my office but no load cells and I would like to test my PLC programming. Can I use a trim pot to simulate the load cells? If so, how can this be done?

Do I need an IT Junction Box to use smart diagnostics with a HI 3010 controller?

Do I need an IT Junction Box to use smart diagnostics with a HI 3010 controller?

When should I use the trim pots on the summing cards?

What are trim pots for on the summing cards? When are they needed?

What is the difference between Series A and Series B on the HI 200DNWM?

What is the difference between Series A and Series B on the HI 200DNWM?

How do I map data from one HI 3000 unit to another HI 3000?

I am using two HI 3030's, one with four channels, one with two. I have one ControlNet card in the 4 channel configuration and I am only going to read and send the gross weight and net weight to the ControLogix. In the dual channel unit I need to map these parameters and transfer them through a HardyLink (Ethernet) network to the four channel unit with the ControlNet card. How do I map weight data from one unit to another unit that has the ControlNet interface?