You have no items in your shopping cart.

New HIDS Drum Scales!

Click Here to Learn More!
Sales: 858.278.2900
Support: 858-292-2710
Visit hardysolutions.cn
menu menu-close
Build Your System
Products
Products
Solutions
Solutions
Customers
Customers
Why Hardy?
Why Hardy?
Soutien
Soutien
Where to Buy
Where to Buy
Find Your Weighing Solution

Knowledgebase

Filter Filter button
Results: 241 - 250 of 828

Categories

How do I set the IP address on a blind remote unit?

How do I set the IP address on a HI 3000 or HI 4000 series blind remote unit?

Why doesn't RSNetworx recognize the HI 200DNWM?

We have several networks set-up using the HI 200DNWM module and C2® load cells. When I go online or scan the network from the RSNetworx program it will not recognize some of the modules. Sometimes it will see the module but then looses it. The green led’s on the module are steady green, and the weight is good. Why doesn't RSNetworx recognize the HI 200DNWM?

How does the ON-OFF menu selection for communications function?

On the HI 3010 or HI 3030, what does the ON-OFF menu selection for communications options do? 

When do I need to update the firmware on my HI 1756WS module?

I'm going to update my AB ControlLogix PLC from version 8.02 to 11.32. Will my HI 1756WS module with version 1.1 firmware still operate correctly without a firmware update?

Why is my HI 1756WS losing connection with ControlLogix?

My HI 1756WS module is losing connection with ControlLogix. I can cycle power and the connection comes back but I lose it again at different times. What could cause this?

Why can't I Auto-Update my HI 3000 or HI 4000 series firmware?

When I try to do an update of the firmware in my HI 3000 or HI 4000 series unit, the update fails. The program will allow me to enter the IP address of the unit or browse for the IP address OK, and it also allows me to browse for the update file and selects it. Then when I click on the "update" button, the program fails. What could be the cause of this?

Do you have a manual for an old digital weight indicator?

Do you still have manuals for older digital weight indicators?

What is the extra wire for on my Hardy Scale cable?

The cable coming out my ANYWEIGH bench or floor scale has an extra wire which is not called out in the manual. All load cell wires are identified, but this extra, heavier gauge wire is not. Should this wire be terminated anywhere or just capped off?

Can I have multiple scales on a single weight controller channel?

Can I have multiple scales on a single weight controller channel?

How fast is the update cycle for the 0-20 mA Output signal?

How fast is the update cycle for the 0-20 mA output signal? Is it safe enough to check the 0-20 mA signal with a PLC every second in order to receive a peak?