Hardy Process Solutions

How do I adjust the analog out on my HI 3030?

Why will my unit not communicate on certain IP addresses?

I had a Hardy unit hooked up to my network and was able to get online with the browser. I then removed this unit and placed another Hardy unit in its place using the same IP address. However, this second unit would not allow me to get online with it, but if I changed to another IP address it works find. Why would the unit not work with one address, even if a different unit works with that address, but would work with a new address?

How do I manually setup Windows Vista Ethernet port?

How do I manually setup a Windows Vista EtherNet port?

How do I flash my Hardy controller with new firmware?

Which Hardy Instrument should I use in my continuous process for rate control?

Do you have an example of doing a read/write over the serial port in the 2151/30 unit?

Do you have a example of setting up and doing a read/write over the RS 232 serial port in the 2151/30 unit?

Where can I find an installation check list for my Hardy weighing hardware?

I am installing a new weighing system with Hardy controller, load points and summing box. Is there a check list of issues I should be aware of?

Does the HI 4060 Rate Controller have a remote pause function?

We use a magnetic read switch on the valve handle to open or close the pause remote function. The 4060 does not have a pause switch and I am able to start the feeder from the front panel when the stop switch is closed. Does the HI 4060 Rate Controller have a remote pause function?

Why can't I get my Hardy 4050 to work with the EN2T/C Ethernet module?

I have a Hardy 4050 Controller, Firmware version 1.0.0.0. We tried upgrading our ENBT module to an EN2T/C in our control logix rack and the scale would not communicate. We put the ENBT module back in and the scale would communicate just fine. Elsewhere in our plant we have replaced an ENBT module with and EN2T/B module without issue. We have 2 Hardy weigh scales running the same HI4050 1.0.0.0 firmware talking to and EN2T/B without issue. Have you had any issues with the Hardy 4050 Weigh Controller talking to and EN2T Series C??

Knowledgebase

Categories