My HI 3030 4 channel controller is using remote I/O with four scales connected to it. Can I calibrate and configure one channel without affecting the remote I/O data being sent to my PLC from the other three channels?
What is the update and response time for Series 3000 Controllers that are connected together on the Hardy Ethernet network using only one PLC interface?
When do I need to remove or leave the jumpers between exc+ sen+ and exc- sen- that come standard on all new Hardy weight controller load cell connectors? When do I need to remove the jumpers from the connector and place them in the Junction Box connector?
When I use C2® calibration on my HI 2110WI or my HI 2151/30WC and try to enter the reference point, an "err 42" appears in the display and I can't calibrate the system. What does "err 42" mean when I try to perform a C2® calibration?
What should I use to connect my PLC-5 to my HI 2151/30WC, HI 2110WI or our old HI 2151/20WC? Can I do block transfers or am I restricted to discrete RIO? My channel 1A is tied up with DH+ and I am starting to think an AB 1771-SN card is the direction I should be going?
I am trying to configure my HI 3000 unit as a master controller for DeviceNet. Can I enter parameters and display the readings from an A-B Panelview if I don't have a PLC?
