Hardy Process Solutions

How can I receive firmware update notifications for my HI 3030?

Why is my HI 4050 weight drifting after I install the Remote I/O option?

My HI 4050 weight reading is stable until I installed the Remote I/O option. After installing the option I am seeing weight fluctuations around 3 in 10,000. Why would the RIO option affect the weight reading stability?

What does a flashing power light indicate on my HI 3000 series controller?

Can I perform mapping from the front panel?

Can I perform mapping from the front panel of my Hardy Instrument?

how do I read the net weight float value so I can get down to a tenth of a pound?

Using DeviceNet, I need to read the float value of the net weight so I can get down to a tenth of a pound (hundredths would be nice too.) When I map HFI4 to DFO0, I get 1112041062. But if I map HFI4 to DIO0, I get 50 (the weight of the weight I'm using.) How do I read the float value and get 50.10 like the Hardy screen says?

Can I set up mapping to create a totalizer in my unit?

Can I set up mapping to create a timer in my unit?

How can we get floating point resolution using SINT?

Can I use HI 3030 with Kistler Morse load cells?

Can I use HI 3030 on a two load cells system with two Kistler Morse, C1-1-03K-X-015-P-UA1 load cells? We had the load cell installed on the tank long time ago, and we want to replace the Kistler Morse controller with the more advanced HI 3030 without replacing the load cells.

Why are the relays clicking on my IT summing card?

I am using a HI215IT-PS1 summing box, 3 Hardy load cells and a Hardy weight controller or PLC module. We are also using C2 cable between summing box and Hardy Instrument, and we are hearing a very loud clicking noise at the summing box. What can be causing this?

Knowledgebase

Categories