You have no items in your shopping cart.

New HIDS Drum Scales!

Click Here to Learn More!
Sales: 858.278.2900
Support: 858-292-2710
Visit hardysolutions.cn
menu menu-close
Build Your System
Products
Products
Solutions
Solutions
Customers
Customers
Why Hardy?
Why Hardy?
Soutien
Soutien
Where to Buy
Where to Buy
Find Your Weighing Solution

Knowledgebase

Filter Filter button
Results: 121 - 130 of 828

Categories

Can you explain the parameters for the HI 1756WS?

Can you explain the parameters for the HI 1756WS?

How do I program the HI 4050 Analog Output option?

How do I program my HI 4050 Analog Output option?

Why is my HI 3030 display frozen?

Why is my HI 3030 display locked up?

Will Hardy Load Cells support my vessel?

I want to install a scale under my new hopper, will Hardy Load Cells support the hopper?

Do you have a manual for the HI 2132?

I have a very old Hardy Batch Controller that I would like to get a manual for. Do you have a manual for the HI 2132?

Why is the AuditTrail link missing on Operation>Diagnostics page of my HI 4050?

Why is the link to the Audit Trail sometimes missing from the Operation>Diagnostics page in my HI 4050 browser?  If I check my SD card with a card reader I can find the Audit Trail file along with the Parameters file.  If I make changes to the parameters file, or load an older, previously saved file, onto the SD card, the Audit Trail link goes away on the Diagnostics page.  Later I find that it has come back.  Why is this intermittent?

Why doesn't my HI 1746WS Comm LED come on?

Upon installation of my HI 1746WS I have a steady green Fault LED, steady green C2 LED, but no Comm LED at all. Why is there no Comm LED lit? If I run the sample ladder logic, the sequence number incremented from 1 to 7 in the set parameter ladder, so I believe it is running.  

What accuracy can I expect on my belt weighing system?

We have a system using 3 load cells (total capacity 675 lbs) and a Hardy Process Solutions weight controller to measure weight and rate on our feed conveyor. The material feed rate continuously varies from 1000 pounds per hour to 10,000 pounds per hour. The speed of the conveyor is fixed at 80 feet per minute +/- 3%.  At the end of the day they totalize, via the PLC, the amount fed. It seems accuracy is around 10%. What accuracy can we expect, assuming our programming is correct? Can you offer suggestions to optimize that?  

Can I map I/O for setpoint output relay for a HI 4050?

How do I map the I/O for setpoint output relay for my HI 4050?

Why is there no data displayed using HI WS100 software?

My HI 1746WS module is communicating to the SLC but we cannot get data using HI WS100 software. Why?