My weight reading is fine until I reach weights of 32,767 lbs. After this, it rolls over to a negative number. Why isn't my instrument reading correct above 32,767 lbs?
Can I calculate the expected Millivolt reading of my scale? I want to place a test weight on the scale and know what the expected signal Mv load cell output increase will be.
My weight reading does not start at zero with an empty vessel or locks at a high weight level. My contractor said something about linear correction. What exactly is linear correction and what are some indications of a poor linear correction?
I have a communications problem between my controller and the PLC. The PLC weight reading is higher than the reading displayed on the front of the controller. What could be the problem?
