My weight reading is fine until I reach weights of 32,767 lbs. After this, it rolls over to a negative number. Why isn't my instrument reading correct above 32,767 lbs?
Can I calculate the expected Millivolt reading of my scale? I want to place a test weight on the scale and know what the expected signal Mv load cell output increase will be.
I have a communications problem between my controller and the PLC. The PLC weight reading is higher than the reading displayed on the front of the controller. What could be the problem?
In our application we must have rigid piping due to the pressure used to bring the ingredient into the tank, so the option of using flex piping is not available. What should we be aware while doing the C2® calibration? How will the rigid piping influence my C2® calibration?
