My weight reading is fine until I reach weights of 32,767 lbs. After this, it rolls over to a negative number. Why isn't my instrument reading correct above 32,767 lbs?
I have a blank display and found the fuse was blown. When I install a correct replacement fuse, it also blows at power up. Why am I blowing fuses on my HI 2151/30WC, HI2110WI, or HI 2151/20WC?
Can I calculate the expected Millivolt reading of my scale? I want to place a test weight on the scale and know what the expected signal Mv load cell output increase will be.
My weight reading does not start at zero with an empty vessel or locks at a high weight level. My contractor said something about linear correction. What exactly is linear correction and what are some indications of a poor linear correction?
I have a HI 2151/20WC, a HI 2151/30WC, and a HI 2110WI and would like to communicate to a Allen Bradley PLC-5. What options are available to accomplish this?
When I power up my Hardy HI 2151/30WC, the unit reads HARDY, SLASH30, WAIT, counts up, says a weight reading and then restarts continuously. Why does my HI 2151/30WC keep initializing?
