Hardy Process Solutions

Results: 51 - 60 of 115

Why can't I see an exact zero reading?

When I send the command to zero or tare the scale the weight reading is not exactly zero. The weight reading goes to a value between +0.05 and -0.01 lbs, and the 3 load cells are 2000 lbs each. Why can't I see an exact zero reading?

What is the current draw for the HI 200DNWM?

I have several applications, all with module HI 200DNWM. One application has only 1 load cell. A second application has 2 load cells. The third application has 4 load cells. The power supply is 24vdc. What is the current draw for each application?

Where are the C2® chips located on the load cell?

Why is my HI 200DNWM status light staying on when I perform a C2® calibration?

Why is the status light staying on when I perform a C2® calibration on my HI 200DNWM?

What is the minimum live load for a HI 2201LT or HI 2204LT to operate?

What is the minimum live load that a HI 2201LT or the HI 2204LT strain gauge transmitters need for span calibration?

When should I use the trim pots on the summing cards?

What are trim pots for on the summing cards? When are they needed?

What is the difference between Series A and Series B on the HI 200DNWM?

How can I configure my HI 200DNWM with a blank screen?

When I try to configure my HI 200DNWM through RSNetworks for DeviceNet, the scroll down arrow options shows me a blank screen. What should I do?

How do I read/write 32 bit words from 16 bit registers?

How can I increase the capacity of my weighing system?

I have been using my Hardy weigh system for years with no problems. It is a 100kg system and now I need to increase the capacity to 200kg. How can I increase my Hardy scale capacity?

knowledgebase

Catégories