Why is my HI 200DNWM status light staying on when I perform a C2® calibration?

The simplest method of doing a C2® calibration on the HI 200 DNWM is to press "The BUTTON". This will only work if Hardy C2® load cells are being used. The HI 200 DNWM LED will go out after about 10-15 seconds, but may take longer depending on the number of load cells used. If the LED does not go out, normally it is because either "The BUTTON" was not held long enough, the load cells are not C2® or they do not have the C2® connections wired properly.