Sometimes it is not possible to do a full rate calibration, Do you have any suggestions to minimize the amount of material used or do the rate calibration while in production?
When I try to do a calibration using the configuration software, it just locks up. How would I do a calibration on the HI 1771 WS without using the Configuration Software?
I have a 1756-WS Module installed in my local rack that I communicate via an ENBT ethernet module. When I browse the rack in RSLinx the Hardy Module is displayed with a yellow question mark and "Unrecognized Device, Hardy 1756-WS (HW REV C)". Is it possible for RSLinx to recognize the device correctly.
