You have no items in your shopping cart.

New HIDS Drum Scales!

Click Here to Learn More!
Sales: 858.278.2900
Support: 858-292-2710
Visit hardysolutions.cn
menu menu-close
Build Your System
Products
Products
Solutions
Solutions
Customers
Customers
Why Hardy?
Why Hardy?
Soutien
Soutien
Where to Buy
Where to Buy
Find Your Weighing Solution

Knowledgebase

Filter Filter button
Results: 271 - 280 of 828

Categories

Can I remotely set the date & time on my HI 3030 with ControlNet?

On a HI 3030 with ControlNet is it possible to set the date and time remotely through the ControlNet connection?

Why does my ControlNet communication fail on my replacement HI 3000 unit?

I have an existing system with an HI 3000 series unit on ControlNet to my PLC. My original HI 3000 series unit failed so I replaced it with a new HI 3000 unit with ControlNet, but the new unit will not communicate over the ControlNet network. What could be the problem?

What does the PID do on my HI 3300 Tension Controller?

I am installing a Tension Control system. Please explain what the PID does. Thanks!

How do I orient my load cells for installation?

Our contractor has installed several load cells upside down, is this a problem? We are also installing some Advantage load point assemblies and would like to know what is the correct orientation?

Which Hardy Instrument can perform a weight totalization function?

Which Hardy Instrument can perform a weight totalization function?

Can I map a "clear tare" through software on my HI 3030?

Is it possible to map a "clear tare" through software on my HI 3030 so I can clear the tare through RSLogix? The following mapping exists through internet explorer for DeviceNet: DFO0=+HFI4, DFO2=+HFI8, DFO4=+HFO21, DIO6=+HSI3, DO7.0=+HI1.6, HO1.0=+DI0.0 This mapping equates to: DFO0(DeviceNet Float Output) = +HFI4(Gross Weight chan 1) DFO2(DeviceNet Float Output) = +HFI8(Net Weight chan 1) DFO4(DeviceNet Float Output) = +HFO21(Tare weight Chan 1) DIO6(DeviceNet Integer Output) = +HSI3(Command Status) DO7.0(DeviceNet Boolean Output) = +HI1.6(Motion) HO1.0(Tare 1 command) = +DI0.0(DeviceNet Boolean Input) Is there an instruction to clear the tare? Suggestions?

How does Rate Of Change (ROC) work?

How does Rate Of Change (ROC) work?

Why is my weigh scale module always in Status Fault 64?

Why is my weigh scale module always in Status Indication 64?

Why can't we get a signal out of our summing junction box?

We cannot get a signal out of our summing junction box? What could be the problem?

How do I set up tags to receive weight data over Ethernet IP?

How do I set up tags to send commands to the controller and receive weight data from my Hardy Instrument over Ethernet IP?