Hardy Process Solutions

Results: 201 - 210 of 540

How do I map a tare command?

Why can't I receive data when the PLC says my HI 3000 series unit is online?

Using a Hardy 3000 series (HI 3010, HI 3030, HI 3300 or HI 3600) with Control Net, why can't I receive data when the PLC says my Hardy Instrument is online? All values received are "0", but the controller has good readings in all channels.

Can you explain the Parameters for the HI 3010?

How do I perform a traditional hard calibration on my HI 2151/30WC or HI 2110WI?

How do I perform a traditional hard calibration on my HI 2151/20WC, HI 2151/30WC or my HI 2110WI?

What are the correct jumper settings for my HI 2151/30WC or HI 2110 WI?

The HI 2151/30WC and HI 2110WI has a jumper listed as Prog/B12/B8 that was not present on the older units. How do I know what to set this jumper to?

When should I perform an IT test on my weight controller?

When should I do the IT test on my weight controller? I understand that when an IT Test is in progress the outputs from the load cells are interrupted. Would this cause errors in the actual weight while my application is weighing?

How do I troubleshoot my HI 3000 series controller?

Do you have guidelines for troubleshooting my HI 3010, or my HI 3030?

Setting up HI 4000 series to ControlLogix via EIP

How do I setup my new HI 4050 or the HI 4060 to communicate to my Control Logix PLC over Ethernet IP?

Can I turn off WAVERSAVER®?

Can I turn off WAVERSAVER® in my Hardy controller?

Knowledgebase

Categories