Hardy Process Solutions

When I change units of measure what else do I need to change?

When I change units of measure on my Hardy weight controller, what else do I need to change?

What is the fill timer under the adjust ingredient menu on the HI 3010?

What is fill/dispense timer under the adjust ingredient menu on the HI 3010?

What is the difference between sequential and simultaneous feed on a HI 3010?

What are the differences between sequential and simultaneous feed using a HI 3010? Please explain dual vs single speed settings and auto fast adjust.

How does the fast weight setting work on the HI 3010?

How does the fast weight setting parameter work on the HI 3010? Please explain how I should use this setting.

When should I use Auto fast adjust under the HI 3010 speed menu?

When would I use or not use Auto fast adjust under the HI 3010 speed menu? I'm getting a small fast weight amount, but my slow feed auto pre act is very large. This gives me erratic batches.

Will the HI 3010 feeder stop during a jog ON time if I reach target weight?

Will the feeder stop during a jog ON time if I reach target weight? I have jog on set to 5 seconds and off for 2 seconds for a total count of 4 jogs. If I reach my target weight half way through a jog on, will the feeder stop?

How does the HI 3010 refill parameter work?

What is the difference between discharge, auto discharge and OK to discharge?

The discharge, auto discharge and OK to discharge parameters on the HI 3010 are confusing. When would I use one discharge type over another discharge?

What data is contained in the 4 bytes from the HI 200DNWM?

I am using the HI 200DNWM module and I noticed there are 4 bytes from the module to the scanner card. Does this contain status information or just the weight ?

What is the difference between zero tolerance and auto zero tolerance parameters on the HI 3010?

What is the difference between the zero tolerance and auto zero tolerance parameters on the HI 3010?

knowledgebase

Catégories