Vous n'avez aucun article dans votre panier.

Nouvelles gammes de batterie HIDS !

Cliquez ici pour en savoir plus !
Sales: 858.278.2900
Support: 858-292-2710
Visit hardysolutions.cn
menu menu-close
Construisez votre système
Products
Products
Solutions
Solutions
Customers
Customers
Why Hardy?
Why Hardy?
Support
Support
Où acheter
Où acheter
Trouvez votre solution de pesage

Base de connaissances

Filtre Filter button
Results: 791 - 800 of 828

Catégories

How do I prevent shock loading on my scale?

One of our customers doesn't understand why their scale needs the load cell replaced on a regular basis. During a visit we noticed the customer dropping a 200 lb gas cylinder on the scale from a height of 4 to 6 inches. We informed the customer that this impact was damaging the load cells. Can you provide additional information about shock loading?

Are Hardy Load Points seismic rated?

Are Hardy Load Points seismic rated?

Can I change modes on the Analog output card from the remote functions?

I'm using a HI 2151/30WC with an analog output option card for the load weight on an overhead crane.  I'm using the remote functions NET & TARE on the input terminals.  When I place the controller in NET mode, using the terminals (or the front pushbutton), the analog output is still in GROSS.  Is there a way to get the analog output option card to output the NET weight when the controller is in NET mode?

How do I setup Profibus on my HI 4000?

I just purchased a new HI 4000 series unit and am not familiar with using Hardy Instruments. How do I setup Profibus on my HI 4000?

Must I re-calibrate my HI 4060 whenever I change option hardware?

I am going to add an option to my HI 4060 and need to know if I must perform a complete calibration after adding or removing any option?

Can I lockout option KEY codes on my HI 3000 or HI 4000 units?

Can the KEY codes to enable an option on my HI 3000 or HI 4000 series controller be locked after unit is configured to prevent unauthorized changes that may disable the option?

How can I get pricing and lead time for a Hardy product?

I am interested in purchasing some Hardy weight controllers and load cells. I do not see pricing and lead times on the Hardy website, so where can I get this information?

Can I transfer a calibration between HI 1771WS modules?

I have a 1771-WS module in a PLC-5 rack that is working ok..  I want to replace this card with my spare card that has never been calibrated.  Is there a way I can use the calibration of the card installed and transfer it to the spare one with out having to do a new calibration? In the calibration menu, there is the "Restore" calibration option. How does this restore work? 

How can I receive firmware update notifications and instructions for my HI 1756-WS or HI 1756-2WS?

How can I receive firmware update notifications for my HI 1756-WS or HI 1756-2WS? Are there instructions to flash my module with the new firmware?

Does the HI 1769WS have Rate Of Change capabilities?

Does the HI 1769WS and/or HI 1769-2WS have Rate Of Change capabilities?