Vous n'avez aucun article dans votre panier.

Nouvelles gammes de batterie HIDS !

Cliquez ici pour en savoir plus !
Sales: 858.278.2900
Support: 858-292-2710
Visit hardysolutions.cn
menu menu-close
Construisez votre système
Products
Products
Solutions
Solutions
Customers
Customers
Why Hardy?
Why Hardy?
Soutien
Soutien
Où acheter
Où acheter
Trouvez votre solution de pesage

knowledgebase

Filtre Filter button
Results: 101 - 110 of 118

Catégories

How do I wire my non-Hardy load cells to the Hardy unit?

How do I wire my non-Hardy load cells to my Hardy unit? I am using non-Hardy Load Cells with a junction box made by the same company that made my load cells. They have an output cable of 7 wires at 24 VDC. How do I connect the cable to the Hardy unit? Can I use C2®?

How do I return an instrument for repair?

How do I return an instrument to Hardy for repair?

Will my Hardy Instrument work with a Load Cell rated at 10 volt excitation?

Will Hardy Weight Controllers and PLC Weigh Modules work with a Load Cell with a 10-volt excitation voltage?

Is it better to use three or four load cells on a scale?

Which is better, using three or four load cells on a scale?

How can I determine the capacity of a load cell?

I am replacing a load cell on an existing scale and unable to read the label. Is there another way to figure out what the capacity of the load cell is?

How do you do a C2® calibration with live weight in the vessel?

I need to use the weight in my tank as a reference point and do a C2® calibration. How do I know that value is accurate if I suspect that my system is out of calibration in the first place?

How can I determine if my load cell is damaged or has a mechanical problem?

What should I do if my empty weight does not return to zero? I think one of my load cells may be damaged. How should I troubleshoot to determine if this is a load cell or a mechanical problem?

What are the sense wires for?

I am trying to install a Hardy Instrument and there are 9 wires: 2 for signal, 2 for excitation, 2 for C2®, 2 for sense and a shield wire. What are the 2 sense wires for?

What is the maximum load cell cable length?

What is the longest length cable I can have on a load cell and still get a full range reading? Does this have to be a manufacturer supplied cable?

Are the Advantage load cells compensated for static or thermal effects?

Are Hardy's Advantage load cells compensated for static effects or thermal effects? How is this compensation accomplished? Is each sensor tested under different thermal conditions or are representative units from a lot used to predict what compensation is appropriate for that lot?