Hardy Process Solutions

How can I verify proper grounding on my weighing system?

How important is a good grounding system on my scale? How can I verify I have a good ground?

What is a Digital I/O option on the HI 4050?

I am considering purchasing a HI 4050 and noticed that there is a Digital I/O interface option available. What is Digital I/O?

Why can't I change the RIO option baud rate on my HI 3000 series controller?

Why can't I change the baud rate on the RIO option in my HI 3000 series controller?

What is the sensitivity of my weight controller?

How do I troubleshoot my HI 2151/30WC?

Do you have guidelines for troubleshooting my HI 2151/30WC?

Can I change modes on the Analog output card from the remote functions?

I'm using a HI 2151/30WC with an analog output option card for the load weight on an overhead crane. I'm using the remote functions NET & TARE on the input terminals. When I place the controller in NET mode, using the terminals (or the front pushbutton), the analog output is still in GROSS. Is there a way to get the analog output option card to output the NET weight when the controller is in NET mode?

How do I setup Profibus on my HI 4000?

I just purchased a new HI 4000 series unit and am not familiar with using Hardy Instruments. How do I setup Profibus on my HI 4000?

Must I re-calibrate my HI 4060 whenever I change option hardware?

I am going to add an option to my HI 4060 and need to know if I must perform a complete calibration after adding or removing any option?

Can I lockout option KEY codes on my HI 3000 or HI 4000 units?

Can the KEY codes to enable an option on my HI 3000 or HI 4000 series controller be locked after unit is configured to prevent unauthorized changes that may disable the option?

How can I get pricing and lead time for a Hardy product?

I am interested in purchasing some Hardy weight controllers and load cells. I do not see pricing and lead times on the Hardy website, so where can I get this information?

knowledgebase

Catégories