We use a magnetic read switch on the valve handle to open or close the pause remote function. The 4060 does not have a pause switch and I am able to start the feeder from the front panel when the stop switch is closed. Does the HI 4060 Rate Controller have a remote pause function?
I have my HI 1746WS in a local SLC-500 rack using RSLOGIX 500. I have set up the card configuration for 32 scanned input and output words with the M0 and M1 length of 128.
From your example program "1746 local example.rss", subroutine 3, I copied the 3 rungs to read the gross weight. It's not reading anything. The one scale is reading zero and the other is reading a negative number. The I:25.18 bits are all 1. What am I doing wrong?
When powered up, the TTS hangs just after RAM Test. It doesn't go on to any other screen nor respond to any key. Should we send it for repair or could you give us some tips to fix it ourselves?
I have a Hardy 4050 Controller, Firmware version 1.0.0.0.
We tried upgrading our ENBT module to an EN2T/C in our control logix rack and the scale would not communicate. We put the ENBT module back in and the scale would communicate just fine.
Elsewhere in our plant we have replaced an ENBT module with and EN2T/B module without issue. We have 2 Hardy weigh scales running the same HI4050 1.0.0.0 firmware talking to and EN2T/B without issue.
Have you had any issues with the Hardy 4050 Weigh Controller talking to and EN2T Series C??
How do I erase old mapping in the HI 4000 or 3000 series units?
We are reusing the controller in a new app and I would like to erase or delete the current mapping.